How To - Installation Tutorials
One of the most important parts of the installation process is to first make sure you have all of the necessary tools to get started.
For this project, you’ll need a:
- Speaker Wire
- Wire Cutters or Sharp Knife
Theater Cabinet Speakers
Step One
Take a look at the plan you devised for your speaker layout. Cut the wire based upon the lengths that the plan calls for but be sure to leave an extra 12-24 inches at each end. This will allow you to the freedom to move your speakers in the future.
Step Two
Now, take your wire cutters or a sharp knife and strip a ½ inch of the jacket off each end of the wire to expose the conductor. Then, twist the ends of the wire to prevent them from fraying.
Step Three
Next, connect the conductors to the binding posts on the bottom or the back of the speaker. Just unscrew the post enough to expose the hole in the terminal post, slip the exposed conductor into the hole and tighten the post. Be sure to double check the polarity of the wires and put the positive end into the red terminal and the negative end in the black terminal both on the back of the speaker and at the amp or receiver end. You now have a fully functionaing home theater system!
Step Four
The final step is to turn on your electronics and test them to make sure they are functioning properly. If your speakers sound “thin” with little bass, check to make sure the positive end of the wire is in the red terminal and the negative end is in the black terminal on all of your connections.
Step Five
Carefully tighten the four mounting screws. This will cause the mounting wings to rotate out behind the mounting surface and secure the speaker in place.
Step Six
After the speaker panel is secured tightly, test for sound. When you are satisfied the speaker is operational, affix grill. As the grill is designed for a snug fit, you’ll need to position one edge into slot first, and press or squeeze around perimeter of grill, while pushing leading edges into grill slot.